Showing all 8 results
Thanks to special additives and pigments, Philament PLA is characterized by easy printability and saturated colors. Even when you print in one layer, you will get the same color you see on the spool. Printable in a wide temperature and printing speed range. The Philament PLA can be used without heated bed, and even with an open 3D printer you will get good printing quality.
The PLA raw material of PLA Advanced was developed especially for manufacturing 3D printing filaments, which has to meet higher printing needs. The objects printed with this filament are stronger and more durable.
Philament PLA Advanced also has a higher heat resistance, up to 85 0C. With this value, it also competes against PETG and ABS filaments. This filament is less brittle, and with excellent layer adhesion we can achieve an exceptionally even surface and more precise printing. The surface of printed object can be shiny at elevated printing temperature and matt at lower temperature, but this depends on the printer also.
Philament PLA Budget filament, just like other Philament PLA products, provide excellent printing results. Their shrinkage is minimal, you can print them even on an unheated bed. They are available in black, white, blue, red and silver gray colors, on 750 gram rolls at a reasonable price.
Two colors on one spool: A total of 1 kg of PLA filament in two colors (colors can’t be selected), approximately equally proportioned. One of the colors is usually black or white. It is easy to use the filament from the spool, the two colors are separated and paralell winded.
6 x 100 gram filament in different colors. Colors: 2-2 black and white, 1-1 from red, blue, green, orange or yellow colors.
Philament products are winded on a transparent plastic spool.
PETG is an ideal choice for 3D printing when reduced warping and high heat resistance are important requirements. Objects printed with PETG are heat resistant up to 85° C, and they are also resistant to chemical influences (e.g. chemicals, solvents, biologically active agents). Printing with PETG is almost as simple as with PLA. PETG is odorless when printing.
An easy-to-use 2,85 mm diameter filament for 3D printing pens. Highly adhesive, nice saturated colors, and easy to work with.
Philament Pen’s raw material is environmentally friendly PLA, and it does not cause unpleasant smells during printing.
Philament Pen is compatible with most popular 3D printing pens, such as e.g. 3Doodler Create, 3Doodler Pro, and any other pens which work with 3 mm diameter filaments.
Use them in “low temp” mode. While drawing, do not touch neither the end of the pen, nor the melted filaments, because it is hot, and may cause burns or damage the heat-sensitive surfaces.